Home › Engine / Hybrid System ยท 2UZ-FE › ENGINE MECHANICAL › CYLINDER BLOCK

CYLINDER BLOCK > REPLACEMENT

for Preparation Click here



1. REPLACE RING PIN

NOTICE:
It is not necessary to remove the ring pin unless it is being replaced.

  1. Remove the ring pin.



  1. Using a plastic-faced hammer, tap in new ring pins until they stop.

    Standard Protrusion:
    Ring Pin
    Specified Condition
    A
    3.5 to 4.5 mm (0.138 to 0.177 in.)
    B
    6.5 to 7.5 mm (0.256 to 0.295 in.)
    C
    9.0 to 10.0 mm (0.354 to 0.394 in.)



    A107618E03



2. REPLACE STRAIGHT PIN

NOTICE:
It is not necessary to remove the straight pin unless it is being replaced.

  1. Remove the straight pin.



  1. Using a plastic-faced hammer, tap in new straight pins until they stop.

    Standard Protrusion:
    Straight Pin
    Specified Condition
    A
    3.5 to 4.5 mm (0.138 to 0.177 in.)
    B
    6.5 to 7.5 mm (0.256 to 0.295 in.)



    A053947E04



3. REPLACE CYLINDER BLOCK TIGHT PLUG

NOTICE:
If water leaks from the tight plug or the plug corrodes, replace it.

  1. Remove the tight plugs.



    A160824E01
  1. Apply adhesive to the holes' inner circumference where the tight plugs contact.

    Adhesive:
    Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent



  1. Using SST and a hammer, tap in new tight plugs as shown in the illustration.

    SST
    09950-60010   (09951-00340)
    09950-70010   (09951-07100)


    A180850E01