Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › YAW RATE AND DECELERATION SENSOR

YAW RATE AND DECELERATION SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL YAW RATE SENSOR
  1. Connect the sensor connector (labeled A), and then attach the clamp (labeled B) to the hole of the sensor bracket.

  1. Install the yaw rate sensor with the 2 nuts (labeled C).

    Torque:
    13 N*m{ 127 kgf*cm , 9 ft.*lbf }

    NOTICE:
    1. Make sure that the sensor is oriented correctly.
    2. If the sensor is dropped, replace it.
    3. Securely connect the connector.

    4. When installing the sensor, avoid impacts to the sensor.


      C154452E02



2. INSTALL REAR CONSOLE BOX ASSEMBLY


B192330
  1. Engage the 6 claws and install the rear console box.

  1. Install the 2 screws and 4 bolts.



    B188223
  1. Connect the connectors.



3. INSTALL CONSOLE BOX CARPET


B188222
  1. Install the console box carpet.



4. INSTALL REAR CONSOLE BOX POCKET


B188221
  1. Install the rear console box pocket.



5. INSTALL REAR UPPER CONSOLE PANEL SUB-ASSEMBLY


    B192328
  1. Connect the connectors.

  1. Engage the 6 clips and install the console panel.

  1. Install the clip.



6. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY


    B161742
  1. Engage the 12 clips and install the console panel.



7. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY


    B167312
  1. Install the shift lever knob and twist it in the direction indicated by the arrow.



8. PERFORM YAW RATE SENSOR ZERO POINT CALIBRATION
(Click here)


9. CHECK YAW RATE SENSOR SIGNAL
(Click here)