STEERING ANGLE SENSOR > INSTALLATION |
| 1. INSTALL STEERING ANGLE SENSOR |
![]() |
Align the pins on the spiral cable with the installation holes on the steering sensor.
Attach the 6 claws and install the spiral cable to the steering sensor.
| 2. INSTALL SPIRAL CABLE SUB-ASSEMBLY |
![]() |
Attach the 3 claws and install the spiral cable with steering sensor.
Connect the connectors to the spiral cable with steering sensor.
| 3. INSTALL UPPER STEERING COLUMN COVER |
![]() |
Attach the claw to install the upper steering column cover.
Attach the 4 clips.
| 4. INSTALL LOWER STEERING COLUMN COVER |
![]() |
Attach the 2 claws to install the lower steering column cover.
Install the 2 screws.
| 5. ADJUST SPIRAL CABLE |
![]() |
Check that the ignition switch is off.
Check that the battery negative (-) terminal is disconnected.
Rotate the spiral cable with steering sensor counterclockwise slowly by hand until it feels firm.
![]() |
Rotate the spiral cable with steering sensor clockwise approximately 2.5 turns to align the marks.
| 6. INSTALL STEERING WHEEL ASSEMBLY |
![]() |
Align the matchmarks on the steering wheel and steering main shaft.
Install the steering wheel set nut.
| 7. INSTALL STEERING PAD |
![]() |
Confirm that the ignition switch is turned off.
Confirm that the negative battery terminal is disconnected.
Connect the horn terminal.
Connect the airbag connector.
Install the steering pad.
![]() |
Using "TORX" socked wrench T30, tighten the 2 screws.
| 8. INSTALL LOWER NO. 3 STEERING WHEEL COVER |
![]() |
Attach the 2 claws to install the cover.
| 9. INSTALL LOWER NO. 2 STEERING WHEEL COVER |
![]() |
Attach the 2 claws to install the cover.
| 10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 11. INSPECT SRS WARNING LIGHT |