SFI SYSTEM > READINESS MONITOR DRIVE PATTERN |
| PURPOSE OF READINESS TESTS |
| CATALYST MONITOR (ACTIVE AIR-FUEL RATIO CONTROL TYPE) |

Preconditions
Drive Pattern
(1) Connect the Techstream to the DLC3.
(2) Turn the ignition switch to ON.
(3) Turn the Techstream on.
(4) Clear DTCs (if output) (Click here).
(5) Start the engine and warm it up.
(6) Drive the vehicle at between 64 km/h and 113 km/h (40 mph and 70 mph) for at least 10 minutes.
Monitor Status
Check the Readiness Monitor status displayed on the Techstream.
If the status does not switch to complete, extend the driving time.
| EVAP SYSTEM MONITOR (KEY OFF TYPE) |
Preconditions
Monitor Conditions
Turn the ignition switch off and wait for 6 hours.
Monitor Status
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Check the Readiness Monitor status displayed on the Techstream.
| AIR-FUEL RATIO (A/F) AND HEATED OXYGEN (HO2) SENSOR MONITORS (ACTIVE AIR-FUEL RATIO CONTROL TYPE) |

Preconditions
Drive Pattern for front A/F sensor and HO2 sensor
(1) Connect the Techstream to the DLC3.
(2) Turn the ignition switch to ON.
(3) Turn the Techstream on.
(4) Clear DTCs (Click here).
(5) Start the engine, and warm it up until the ECT reaches 75°C (167°F) or higher.
(6) Drive the vehicle at between 60 km/h (40 mph) and 120 km/h (75 mph) for at least 10 minutes.
(7) Change the transmission to 2nd gear.
(8) Accelerate the vehicle to 60 km/h (40 mph) or more by depressing the accelerator pedal for at least 10 seconds.
(9) Soon after performing step (8) above, release the accelerator pedal for at least 5 seconds without depressing the brake pedal in order to execute fuel-cut control.
(10) Allow the vehicle to decelerate until the vehicle speed declines to less than 10 km/h (6 mph).
(11) Repeat steps from (8) through (10) above at least 3 times in one driving cycle.
Monitor Status
Check the Readiness Monitor status displayed on the Techstream.
If the status does not switch to complete, make sure that the preconditions have been met, and then perform steps from (5) through (11) in the Drive Pattern above.
| AIR-FUEL RATIO (A/F) AND HEATED OXYGEN (HO2) SENSOR HEATER MONITORS (FRONT A/F AND REAR HO2 SENSOR TYPE) |

Preconditions
Drive Pattern
(1) Connect the Techstream to the DLC3.
(2) Turn the ignition switch to ON.
(3) Turn the Techstream on.
(4) Clear DTCs (if output) (Click here).
(5) Start the engine.
(6) Allow the engine to idle for 10 minutes or more.
(7) Drive the vehicle at 40 km/h (25 mph) or more for at least 2 minutes.
Monitor Status
Check the Readiness Monitor status displayed on the Techstream.
If the status does not switch to complete, make sure that the preconditions have been met, and repeat steps from (5) to (7) described in the Drive Pattern above.