Home › Vehicle Interior › DOOR LOCK › POWER DOOR LOCK CONTROL SYSTEM

POWER DOOR LOCK CONTROL SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here



READ DATA LIST

HINT:
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

  1. Connect the Techstream to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the Techstream on.

  4. Enter the following menus: Body Electrical / Main Body or Back Door P/W or Driver Door / Data List/

  5. Read the Data List according to the display on the Techstream.

    Main Body (Main Body ECU) 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    D Door Courtesy SW
    Driver side door courtesy light switch signal/ON or OFF
    ON: Driver side door is OPEN
    OFF: Driver side door is CLOSED
    -
    P Door Courtesy SW
    Front passenger side door courtesy light switch signal/ON or OFF
    ON: Front passenger side door is OPEN
    OFF: Front passenger side door is CLOSED
    -
    RR Door Courtesy SW
    Rear right door courtesy light switch signal/ON or OFF
    ON: Rear right door is OPEN
    OFF: Rear right door is CLOSED
    -
    RL Door Courtesy SW
    Rear left door courtesy light switch signal/ON or OFF
    ON: Rear left door is OPEN
    OFF: Rear left door is CLOSED
    -
    D-Door Lock Pos SW
    Driver side door lock position switch signal/ON or OFF
    ON: Driver side door is unlocked
    OFF: Driver side door is locked
    -
    P-Door Lock Pos SW
    Front passenger side door lock position switch signal/ON or OFF
    ON: Front passenger side door is unlocked
    OFF: Front passenger side door is locked
    -
    RR-Door Lock Pos SW
    Rear passenger side door lock position switch signal/ON or OFF
    ON: Rear passenger side door is unlocked
    OFF: Rear passenger side door is locked
    -
    RL-Door Lock Pos SW
    Rear driver side door lock position switch signal/ON or OFF
    ON: Rear driver side door is unlocked
    OFF: Rear driver side door is locked
    -
    Back Door Open
    Back door lock signal/Permit or Prohibit
    Permit: Back door is UNLOCK
    Prohibit: Back door is LOCK
    -
    Door Lock SW-Lock
    Door control switch lock signal/ON or OFF
    ON: Door control switch is pushed to LOCK
    OFF: Door control switch is not pushed to LOCK
    -
    Door Key SW-Lock
    Driver door lock/unlock switch lock signal (key-linked lock switch)/ON or OFF
    ON: Driver side door key cylinder is turned to LOCK
    OFF: Driver side door key cylinder is turned to UNLOCK
    -
    D Door Key SW-UL
    Driver door lock/unlock switch unlock signal (key-linked unlock switch)/ON or OFF
    ON: Driver side door key cylinder is turned to UNLOCK
    OFF: Driver side door key cylinder is turned to LOCK
    -

    Back Door P/W (Back Door ECU) 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Key Switch Operation Locked
    Back door lock/unlock switch lock signal ON or OFF
    ON: Back door key cylinder is turned to LOCK
    OFF: Back door key cylinder is turned to UNLOCK
    -
    Key Switch Operation Unlocked
    Back door lock/unlock switch unlock signal ON or OFF
    ON: Back door key cylinder is turned to UNLOCK
    OFF: Back door key cylinder is turned to LOCK
    -
    Back Door Courtesy SW
    Back door courtesy light switch signal/ON or OFF
    ON: Back door is OPEN
    OFF: Back door is CLOSED
    -

    Master Switch 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Door Lock Switch Status
    Driver door lock switch signal ON or OFF
    ON: Door lock switch is turned to LOCK
    OFF: Door lock switch is not turned
    -
    Door Unlock Switch Status
    Driver door unlock switch signal ON or OFF
    ON: Door unlock switch is turned to UNLOCK
    OFF: Door lock switch is not turned
    -


PERFORM ACTIVE TEST

HINT:
Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

  1. Connect the Techstream to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the Techstream on.

  4. Enter the following menus: Body Electrical / Main Body / Active Test/

  5. Perform the Active Test according to the display on the Techstream.

    Main Body (Main Body ECU) 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Door Lock
    Door lock motor
    LOCK/UNLOCK
    -
    D-Door Unlock
    Driver door lock motor
    ON/OFF
    -
    Trunk and Back-Door Open
    Back door lock motor
    ON/OFF
    -