FRONT AIRBAG SENSOR > INSTALLATION |
| 1. INSTALL FRONT AIRBAG SENSOR |
![]() |
Engage the guide and install the airbag sensor with the nut.
Confirm that the ignition switch is turned off.
Confirm that the negative battery terminal is disconnected.
Connect the airbag connector.
![]() |
Check that the CPA is in the provisionally locked state.
![]() |
Push the CPA until it makes a click sound.
Confirm that the rear side of the housing and the CPA rear surface are tightly fitted together.
Confirm that there is no looseness by shaking the front airbag sensor.
| 2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 3. INSPECT SRS WARNING LIGHT |