Home › Drivetrain ยท AB60E AUTOMATIC TRANSMISSION / TRANSAXLE › AUTOMATIC TRANSMISSION SYSTEM

AUTOMATIC TRANSMISSION SYSTEM > HYDRAULIC TEST

for Preparation Click here



PERFORM HYDRAULIC TEST


  1. Measure the line pressure.

    CAUTION:
    The line pressure test should always be performed with at least 2 people. One person should observe the condition of the wheels and wheel chocks while the other is performing the test.

    NOTICE:
    1. Perform the test at the normal operating ATF (Automatic Transmission Fluid) temperature: 50 to 80°C (122 to 176°F).
    2. Be careful to prevent SST hose from interfering with the exhaust pipe.
    3. This check must be conducted after checking and adjusting the engine.
    4. Perform the test with the A/C OFF.
    5. When conducting stall test, do not continue for more than 5 seconds.


    1. Warm up the ATF (Automatic Transmission Fluid).

    2. Turn the ignition switch off.

    3. Lift the vehicle up.



    4. C177721E01
    5. Remove the test plug on the transmission case center right side and connect SST.

      SST
      09992-00095   (09992-00231, 09992-00271)

    6. Lower the vehicle.

    7. Fully apply the parking brake and chock the 4 wheels.

    8. Start the engine and check the idling speed.

    9. Keep your left foot pressed firmly on the brake pedal and move the shift lever to D.

    10. Measure the line pressure when the engine is idling.

    11. Fully depress the accelerator pedal with your right foot. Quickly read the highest line pressure when the engine speed reaches the stall speed.

    12. In the same manner, perform the test with the shift lever in R.

      Specified Line Pressure 
      Condition
      D Position kPa (kgf/cm2, psi)
      R Position kPa (kgf/cm2, psi)
      Idling
      350 to 430 kPa
      (3.6 to 4.4 kgf/cm2, 51 to 62 psi)
      540 to 650 kPa
      (5.5 to 6.6 kgf/cm2, 78 to 94 psi)
      Stall speed
      1170 to 1340 kPa
      (11.9 to 13.7 kgf/cm2, 170 to 194 psi)
      1540 to 1750 kPa
      (15.7 to 17.8 kgf/cm2, 223 to 254 psi)

      Evaluation 
      Problem
      Possible Cause
      Measured values at both positions are higher than specified pressure
      1. Shift solenoid valve SLT defective
      2. Regulator valve defective
      Measured values at both positions are lower than specified pressure
      1. Shift solenoid valve SLT defective
      2. Regulator valve defective
      3. Oil pump defective
      Pressure is low in D position only
      1. D position circuit fluid leak
      2. Clutch No. 1 (C1) defective
      Pressure is low in R position only
      1. R position circuit fluid leak
      2. Clutch No. 3 (C3) defective
      3. Brake No. 4 (B4) defective