TIRE PRESSURE WARNING SYSTEM > SYSTEM DESCRIPTION |
| DESCRIPTION OF SYSTEM |
Each tire pressure warning valve and transmitter is equipped with a tire pressure sensor and transmitter and is installed in each tire wheel. The sensor measures the tire pressure. The measured value and transmitter ID are transmitted to the tire pressure warning antenna and receiver on the body as radio waves and then sent to the tire pressure warning ECU from the tire pressure warning antenna and receiver. If the transmitter ID has already been registered, the ECU compares the measured air pressure value with the specified value. When the value is less than the specified value registered in the tire pressure warning ECU, the warning light on the combination meter turns on.
The tire pressure warning reset switch addresses the differences in the standard pressure of the tire.

| INITIAL CHECK |
![]() |
After the ignition switch is turned to ON, the tire pressure warning light turns on for 3 seconds and then turns off.
| Trouble Area | Proceed to |
| Tire pressure warning light circuit |
Click here
|
| WHEN TIRE PRESSURE WARNING LIGHT IS LIT |
When the tire pressure warning light does not go off, or when it turns on during driving, check the tire pressure. If the tire pressure warning light turns on within several hours after adjusting the tire pressure, the tire may have a slow air leak.
Under the following conditions, the system may not function properly.
The system will be disabled in the following conditions:
(When the condition becomes normal, the system will work properly.)
The system may be disabled in the following conditions:
(When the condition becomes normal, the system will work properly.)
If a tire pressure warning valve and transmitter is removed from a wheel, replace the grommets.
After removing and installing the ECU or a sensor, check for a DTC and verify that it is a normal code.
| FUNCTION OF COMPONENTS |
| Component | Function |
| Tire pressure warning valve and transmitter | Combined as a single unit with a disc wheel air valve, it measures tire pressure and temperature and transmits a transmitter ID for measurement values and identification. Has a built-in battery. |
| Tire pressure warning antenna and receiver | Receives signals from a transmitter and sends the signals to the tire pressure warning ECU. |
| Tire pressure warning ECU | Receives the signal from the receiver and identifies it as the vehicle's own signal. If the measured value is equal to or lower than the specified value, it transmits a signal so that the tire pressure warning light on the combination meter turns on. |
| Tire pressure warning light | Located in the combination meter, it informs the driver of lowered tire pressure and system failure. |
| Tire pressure warning reset switch | Enters the initialization mode for change of the standard pressure. |
| TIRE PRESSURE WARNING RESET SWITCH |