TIRE PRESSURE WARNING SYSTEM > DIAGNOSIS SYSTEM |
| CHECK BATTERY VOLTAGE |
| DIAGNOSIS SYSTEM |
Warning light
![]() |
When there is a problem with the tire pressure warning system, the tire pressure warning light blinks at 0.5-second intervals, and turns on after 1 minute.
DTCs (Normal mode)
DTCs are memorized in the tire pressure warning ECU and read by the blinks of the tire pressure warning light or by using the Techstream (Click here).
Test mode
By switching from normal mode into test mode (input signal check), you can inspect the tire pressure warning antenna and receiver, each tire pressure warning valve and transmitter, and vehicle speed sensor (Click here).
| CHECK TIRE PRESSURE WARNING LIGHT |
![]() |
Turn the ignition switch to ON.
Check that the tire pressure warning light turns on for 3 seconds.
If the warning check result is not normal, proceed to the troubleshooting for the tire pressure warning light circuit.
| Trouble Area | See Procedure |
| Tire pressure warning light circuit |
Click here
|
| TIRE PRESSURE WARNING LIGHT CHART |
| Condition | Immediately after Turning Ignition Switch ON | Always | ||||||
| Warning Light Output Pattern | ||||||||
| Turns on for 3 Seconds | Goes Off | Turns On | Blinks for 1 Minute and then Illuminates*1 | Blinks*2 | Blinks*3 | Blinks*4 | Output DTC | |
| Normal | ○ | ○ | - | - | - | - | - | - |
| Low tire pressure | ○ | - | ○ | - | - | - | - | - |
| System failure | ○ | - | - | ○ | - | - | - | - |
| Test mode | ○ | - | - | - | ○ | - | - | - |
| Initialization | ○ | - | - | - | - | ○ | - | - |
| ECU connector poorly connected | - | - | - | ○*5 | - | - | - | - |
| TC ground (DTC is output) | ○ | - | - | - | - | - | - | ○ |
| TC ground (DTC is not output) | ○ | - | - | - | - | - | ○ | - |
![]() |
![]() |
![]() |
![]() |
![]() |