TIRE PRESSURE WARNING SYSTEM > REGISTRATION |
| 1. DESCRIPTION OF CODE REGISTRATION |
Before registration
If replacing the tire pressure warning ECU:
If replacing the tire pressure warning valve and transmitter.

| 2. REGISTER TRANSMITTER ID |
Set the air pressure of all tires to the specified value .
Turn the ignition switch off.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON and turn the Techstream on.
Enter the following menus: Chassis / Tire Pressure Monitor / Utility / ID Registration.
Perform the following procedures displayed on the screen.
Confirmation of transmitter ID registration.
Enter the following menus: Chassis / Tire Pressure Monitor / Data List.
Read the "ID Tire Inflation Pressure" values.
Confirm that the data of tire pressure of all tires are displayed on the screen.