POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM > FREEZE FRAME DATA |
| FREEZE FRAME DATA |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON and check the freeze frame data by following the prompts on the Techstream screen.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Tilt Position | Current tilt position data / min.: 0, max.: 65535 | 28672 to 36864 | - |
| Telesco Position | Current telescopic position data / min.: 0, max.: 65535 | 28672 to 36864 | - |
| Tilt Return Position | Memorized tilt return position data / min.: 0, max.: 65535 | 28672 to 36864 | - |
| Telesco Return Position | Memorized telescopic return position data / min.: 0, max.: 65535 | 28672 to 36864 | - |
| Tilt Up Limit Position | Uppermost tilt position data / min.: 0, max.: 65535 | 28672 to 36864 | - |
| Tilt Down Limit Position | Lowermost tilt position data / min.: 0, max.: 65535 | 28672 to 36864 | - |
| Telesco Short Limit Pos | Shortest telescopic position data / min.: 0, max.: 65535 | 28672 to 36864 | - |
| Telesco Long Limit Pos | Longest telescopic position data / min.: 0, max.: 65535 | 28672 to 36864 | - |
| Tilt Up Switch | Input state of tilt up by manual switch / ON or OFF | ON: Tilt up is activated by manual switch OFF: Tilt up is not activated by manual switch | - |
| T&T Manual SW Data | Voltage data of manual switch / min.: 0 V, max.: 5 V | Neutral position: Below 0.2 V Tilt up: 1.67 to 2.13 V Tilt down: 0.54 to 0.74 V Telescopic contract: 1.08 to 1.40 V Telescopic extend: 2.22 to 2.77 V | - |
| Power Source Voltage | Voltage data of power supply / min.: 0 V, max.: 20 V | Actual power supply voltage 11 to 14 V | - |
| Freeze Speed Info | Vehicle speed data / min: 0 km/h (0 mph), max.: 255 km/h (158 mph) | Actual vehicle speed | - |
| IG Switch (CAN) | Communication state of power switch / ON or OFF | ON: Communication is normal OFF: Communication is interrupted | - |
| Key Switch (CAN) | Communication state of key switch signal / ON or OFF | ON: Communication is normal OFF: Communication is interrupted | - |
| Key Code Confirm (CAN) | Communication state of key code confirmation signal / ON or OFF | ON: Communication is normal OFF: Communication is interrupted | - |
| The Number of DTCs | Number of diagnosis codes / min.: 0, max.: 255 | Actual number of diagnosis codes | - |