Home › Audio/Visual/Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM

NAVIGATION SYSTEM > Navigation Receiver Assembly Power Source Circuit

for Preparation Click here


DESCRIPTION

The circuit provides power to the navigation receiver assembly.

WIRING DIAGRAM


E138083E04


INSPECTION PROCEDURE

1.INSPECT FUSES (RAD NO. 1, ACC)


    E160630E05
  1. Remove the ACC fuse from the main body ECU.

  1. Remove the RAD NO. 1 fuse from the engine room junction block.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    RAD NO. 1 fuse
    Always
    Below 1 Ω
    ACC fuse

  1. Install the fuses.



NG
REPLACE FUSES
OK


2.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER - BATTERY AND BODY GROUND)


    E138077E04
  1. Disconnect the I20 navigation receiver assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I20-20 (GND) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    I20-1 (B) - Body ground
    Always
    11 to 14 V
    I20-11 (ACC) - Body ground
    Ignition switch ACC

  1. Reconnect the navigation receiver assembly connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)