Home › Audio/Visual/Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM

NAVIGATION SYSTEM > Reverse Signal Circuit

for Preparation Click here


DESCRIPTION

The navigation receiver receives a reverse signal from the park/neutral position and information about the navigation antenna, and then adjusts vehicle position.

WIRING DIAGRAM


E138079E06


INSPECTION PROCEDURE

1.INSPECT NAVIGATION RECEIVER ASSEMBLY


    E146425E02
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    I6-5 (REV) - Body ground
    Ignition switch ACC, shift lever in R
    11 to 14 V
    Ignition switch ACC, shift lever in P
    Below 1 V



NG
Go to step 2
OK

REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)  

2.CHECK HARNESS AND CONNECTOR (SWITCH - NAVIGATION RECEIVER - BATTERY AND BODY GROUND)


    E138080E03
  1. Disconnect the I6 navigation receiver assembly connector.

  1. Disconnect the D21 park / neutral position switch assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    D21-1 (RL) - I6-5 (REV)
    Always
    Below 1 Ω
    D21-1 (RL) - Body ground
    Always
    10 kΩ or higher

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    D21-2 (RB) - Body ground
    Ignition switch off
    Below 1 V
    Ignition switch ACC
    11 to 14 V

  1. Reconnect the navigation receiver assembly connector.

  1. Reconnect the park / neutral position switch assembly connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.INSPECT PARK / NEUTRAL POSITION SWITCH ASSEMBLY


    E120122E14
  1. Disconnect the D21 park / neutral position switch assembly connector

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Shift Lever Position
    Specified Condition
    1 (RL) - 2 (RB)
    Ignition switch ACC, shift lever in R
    Below 1 Ω
    Ignition switch ACC, shift lever in P
    10 kΩ or higher

    Result 
    Result
    Proceed to
    OK
    A
    NG (for A750E)
    B
    NG (for A750F)
    C
    NG (for AB60E)
    D
    NG (for AB60F)
    E

  1. Reconnect the park / neutral position switch assembly connector.



B
REPLACE PARK / NEUTRAL POSITION SWITCH ASSEMBLY (Click here)

C
REPLACE PARK / NEUTRAL POSITION SWITCH ASSEMBLY (Click here)

D
REPLACE PARK / NEUTRAL POSITION SWITCH ASSEMBLY (Click here)

E
REPLACE PARK / NEUTRAL POSITION SWITCH ASSEMBLY (Click here)
A

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)