Home › Audio/Visual/Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Radio Receiver Power Source Circuit

for Preparation Click here


DESCRIPTION

This circuit provides power to the radio receiver assembly.

WIRING DIAGRAM


E146480E02


INSPECTION PROCEDURE

1.INSPECT FUSES (RAD NO. 1, ACC)


    E160630E01
  1. Remove the RAD NO. 1 fuse from the engine room junction block.

  1. Remove the ACC fuse from the main body ECU.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    RAD NO. 1 fuse
    Always
    Below 1 Ω
    ACC fuse

  1. Install the fuses.



NG
REPLACE FUSES
OK


2.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - BATTERY AND BODY GROUND)


    E146481E02
  1. Disconnect the I1*1, I4*2 and I9*2 radio receiver assembly connectors.

    HINT:
    *1: for 8 Speakers
    *2: for 14 Speakers

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    for 8 Speakers 
    Tester Connection
    Condition
    Specified Condition
    I1-7 (GND) - Body ground
    Always
    Below 1 Ω
    for 14 Speakers 
    Tester Connection
    Condition
    Specified Condition
    I4-20 (GND) - Body ground
    Always
    Below 1 Ω
    I9-14 (GND) - Body ground

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    for 8 Speakers 
    Tester Connection
    Switch Condition
    Specified Condition
    I1-4 (B) - Body ground
    Always
    11 to 14 V
    I1-3 (ACC) - Body ground
    Ignition switch ACC
    for 14 Speakers 
    Tester Connection
    Switch Condition
    Specified Condition
    I4-1 (B) - Body ground
    Always
    11 to 14 V
    I9-5 (+B) - Body ground
    I4-11 (ACC) - Body ground
    Ignition switch ACC
    I9-16 (ACC) - Body ground

  1. Reconnect the radio receiver assembly connectors.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)