Home › Audio/Visual/Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Stereo Component Amplifier Power Source Circuit

for Preparation Click here


DESCRIPTION

This circuit provides power to the stereo component amplifier assembly.

WIRING DIAGRAM


E146482E04


INSPECTION PROCEDURE

1.INSPECT FUSES (AMP, ACC)


    E160630E02
  1. Remove the AMP fuse from the engine room junction block.

  1. Remove the ACC fuse from the main body ECU.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    AMP fuse
    Always
    Below 1 Ω
    ACC fuse

  1. Install the fuses.



NG
REPLACE FUSES
OK


2.CHECK HARNESS AND CONNECTOR (STEREO COMPONENT AMPLIFIER - BATTERY AND BODY GROUND)


    E160626E01
  1. Disconnect the I17 and I16 stereo component amplifier assembly connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I16-2 (GND) - Body ground
    Always
    Below 1 Ω
    I16-6 (GND2) - Body ground

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    I16-1 (+B) - I16-2 (GND)
    Always
    11 to 14 V
    I16-3 (+B2) - I16-2 (GND)
    I17-12 (ACC) - I16-2 (GND)
    Ignition switch ACC

  1. Reconnect the stereo component amplifier assembly connectors.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)