HOOD > ADJUSTMENT |

| 1. INSPECT HOOD |
Check that the clearance measurements are within the standard ranges.

| Area | Measurement | Area | Measurement |
| A | 4.0 to 7.0 mm (0.157 to 0.276 in.) | B | -1.5 to 1.5 mm (-0.059 to 0.059 in.) |
| 2. ADJUST HOOD |
![]() |
Loosen the 4 hood side hinge bolts.
Move the hood to adjust the clearance to within the standard range.
Tighten the 4 hood side hinge bolts after the adjustment.
![]() |
Adjust the height of the hood front end by turning the cushion rubber.
Adjust the hood lock.
![]() |
Remove the hood lock nut cap.
![]() |
Loosen the 2 bolts and nut.
![]() |
Adjust the hood lock position so that the striker can enter it smoothly.
![]() |
Tighten the 2 bolts and nut after the adjustment.