Home › Drivetrain ยท AB60E AUTOMATIC TRANSMISSION / TRANSAXLE › VALVE BODY ASSEMBLY

VALVE BODY ASSEMBLY > INSTALLATION

for Preparation Click here



1. INSTALL TRANSMISSION VALVE BODY ASSEMBLY


D027914E04
  1. Install the spring and check ball body.



    C162146E01
  1. Insert the pin of the manual valve into the hole of the manual valve lever.



    C162147E01
  1. Install the 19 bolts.

    Torque:
    11 N*m{ 112 kgf*cm , 8 ft.*lbf }

    HINT:
    Each bolt length is indicated below.
    36 mm (1.42 in.) for bolt A
    25 mm (0.984 in.) for bolt B
    45 mm (1.77 in.) for bolt C
    50 mm (1.97 in.) for bolt D

  1. Install the detent spring and detent spring cover with the bolt.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }



2. CONNECT TRANSMISSION WIRE


    C161112E02
  1. Connect the 9 connectors to the solenoid valves.

  1. Connect the 2 ATF temperature sensors with the 2 clamps and 2 bolts.

    1. for bolt A

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

    1. for bolt B

    Torque:
    11 N*m{ 112 kgf*cm , 8 ft.*lbf }

    HINT:
    Each bolt length is indicated below.
    12 mm (0.472 in.) for bolt A

    36 mm (1.41 in.) for bolt B



3. INSTALL VALVE BODY OIL STRAINER ASSEMBLY
  1. Coat a new O-ring with ATF and install it to the oil strainer.



    C178807
  1. Install the oil strainer with the 4 bolts.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }



4. INSTALL AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY


    C178809E02
  1. Install the 4 transmission oil cleaner magnets to the oil pan.



    C178808E02
  1. Install a new gasket and the oil pan with the 12 bolts.

    Torque:
    7.4 N*m{ 75 kgf*cm , 65 in.*lbf }


    NOTICE:
    C157303E01
    1. Make sure that there is no oil or foreign matter on the gasket seal surface and oil pan contact surface.
    2. Install the gasket so that there is no slack in the gasket, and make sure the seal surface's entire circumference is level.
    3. Make sure that the 9 gasket drop prevention protrusions are set on the oil pan.
    4. When tightening the oil pan, make sure that the gasket is not pinched between the gasket tightening area's sleeve and the transmission's seal surface.



5. ADD AUTOMATIC TRANSMISSION FLUID

Fluid type:
Toyota Genuine ATF WS

HINT:
Fill the transmission with the amount of fluid listed in the table below.

Standard Capacity:
Repair
Fill amount
Transmission pan and drain plug removal
2.1 liters (2.2 US qts, 1.9 Imp. qts)
Transmission valve body removal
4.7 liters (5.0 US qts, 4.1 Imp. qts)
Torque converter removal
6.1 liters (6.4 US qts, 5.4 Imp. qts)



6. ADJUST AUTOMATIC TRANSMISSION FLUID
  1. Adjust automatic transmission fluid (Click here).



7. INSPECT FOR AUTOMATIC TRANSMISSION FLUID LEAK