OIL PUMP > INSPECTION |
| 1. INSPECT FRONT OIL PUMP BODY SUB-ASSEMBLY |
![]() |
Using a dial indicator, measure the inside diameter of the oil pump body bush.
| 2. INSPECT STATOR SHAFT ASSEMBLY |
![]() |
Using a dial indicator, measure the inside diameter of the stator shaft bush.
| Stator Shaft Bush | Diameter |
| Front side | 21.577 mm (0.849 in.) |
| Rear side | 32.08 mm (1.26 in.) |
| 3. INSPECT CLEARANCE OF OIL PUMP ASSEMBLY |
![]() |
Push the driven gear to one side of the body.
Using a feeler gauge, measure the body clearance.
![]() |
Using a feeler gauge, measure the tip clearance between the driven gear teeth and drive gear teeth.
![]() |
Using a steel straightedge and feeler gauge, measure the side clearance of both gears.
| Mark | Thickness |
| 0 | 10.74 to 10.749 mm (0.42283 to 0.42319 in.) |
| 1 | 10.75 to 10.759 mm (0.42323 to 0.42358 in.) |
| 2 | 10.76 to 10.77 mm (0.42362 to 0.42401 in.) |
| 3 | 10.771 to 10.78 mm (0.42405 to 0.42441 in.) |
| 4 | 10.781 to 10.79 mm (0.42445 to 0.42480 in.) |
| 4. INSPECT FRONT OIL PUMP DRIVE GEAR ROTATION |
![]() |
Place the oil pump body on the torque converter clutch.
Check that the drive gear rotates smoothly.
Remove the oil pump assembly from the torque converter.