Home › Drivetrain ยท AB60E AUTOMATIC TRANSMISSION / TRANSAXLE › OIL PUMP

OIL PUMP > REASSEMBLY

for Preparation Click here



1. INSTALL FRONT OIL PUMP OIL SEAL


C161807E01
  1. Using SST and a hammer, tap in a new oil seal.

    SST
    09950-60010   (09951-00650)
    09950-70010   (09951-07100)

    HINT:
    The oil seal end should be flush with the outer edge of the pump body.

  1. Coat the lip of the oil seal with MP grease.



2. FIX FRONT OIL PUMP BODY SUB-ASSEMBLY
  1. Place the oil pump body on the torque converter clutch.



3. INSTALL FRONT OIL PUMP DRIVEN GEAR


C161799
  1. Coat the driven gear with ATF.

  1. Install the driven gear to the oil pump body.



4. INSTALL FRONT OIL PUMP DRIVE GEAR


C161798
  1. Coat the drive gear with ATF.

  1. Install the drive gear to the oil pump body.



5. INSTALL FRONT OIL PUMP BODY O-RING


C161797E01
  1. Coat a new O-ring with ATF and install it to the oil pump body.



6. INSTALL STATOR SHAFT ASSEMBLY


C161796E01
  1. Align the stator shaft with the bolt holes.

  1. Install the 17 bolts.

    Torque:
    11 N*m{ 112 kgf*cm , 8 ft.*lbf }



7. INSTALL CLUTCH DRUM OIL SEAL RING


C161795E02
  1. Coat 3 new oil seal rings with ATF.

  1. Squeeze the ends of the 3 oil seal rings together so that the overlap distance is 8 mm (0.314 in.) or less, and then install them to the starter shaft groove.

    NOTICE:
    Do not excessively widen the rings.

    HINT:
    After installing the oil seal rings, check that they rotate smoothly.



8. INSPECT OIL PUMP DRIVE GEAR ROTATION


C161806
  1. Place the oil pump body on the torque converter clutch.

  1. Check that the drive gear rotates smoothly.

  1. Remove the oil pump assembly from the torque converter.



9. INSTALL FRONT OIL PUMP BODY O-RING


C162762E01
  1. Coat a new O-ring with ATF and install it to the oil pump.