Home › Audio/Visual/Telematics › PARK ASSIST / MONITORING › REAR VIEW MONITOR SYSTEM

REAR VIEW MONITOR SYSTEM > TERMINALS OF ECU

for Preparation Click here



CHECK TELEVISION CAMERA ASSEMBLY

E115535E02

  1. Disconnect the V17 camera connector.

  2. Measure the voltage and resistance according to the value(s) in the table below.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    V17-3 (CGND) - Body ground
    W - Body ground
    Ground
    Always
    Below 1 Ω
    V17-4 (CB+) - V17-3 (CGND)
    B - W
    Power source
    Ignition switch ON, shift lever in R
    5.5 to 7.05 V
    If the result is not as specified, there may be a malfunction on the wire harness side.

  3. Reconnect the V17 camera connector.

  4. Measure the waveform according to the value(s) in the table below.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    V17-2 (CV+) - V17-1 (CV-)
    R - L
    Display signal
    Ignition switch ON, shift lever in R
    Waveform
    If the result is not as specified, the camera may have a malfunction.



  5. E119731E01
  6. Using an oscilloscope, check the waveform.
    Reference 
    Terminal Condition
    V17-2 (CV+) - V17-1 (CV-)
    Tester Range
    0.2 V/DIV., 0.2 μsec./DIV.
    Vehicle Condition
    Ignition switch ON, shift lever R position


CHECK NAVIGATION RECEIVER ASSEMBLY (Click here)