AUDIO AND VISUAL SYSTEM > Sound Signal Circuit between Radio Receiver and Stereo Component Amplifier |

| 1.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - STEREO COMPONENT AMPLIFIER) |
![]() |
Disconnect the I4 radio receiver assembly connector.
Disconnect the I17 stereo component amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I4-9 (L+) - I17-3 (L+) | Always | Below 1 Ω |
| I4-19 (L-) - I17-2 (L-) | ||
| I4-8 (R+) - I17-5 (R+) | ||
| I4-18 (R-) - I17-4 (R-) | ||
| I4-10 (SLD) - I17-6 (SLD) | ||
| I4-9 (L+) - Body ground | Always | 10 kΩ or higher |
| I4-19 (L-) - Body ground | ||
| I4-8 (R+) - Body ground | ||
| I4-18 (R-) - Body ground |
Reconnect the radio receiver assembly connector.
Reconnect the stereo component amplifier assembly connector.
|
| ||||
| OK | ||
| ||