Home › Audio/Visual/Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM

NAVIGATION SYSTEM > Microphone Circuit between Microphone and Navigation Receiver Assembly

for Preparation Click here


DESCRIPTION

This circuit sends a microphone signal from the microphone amplifier assembly to the navigation receiver assembly.

WIRING DIAGRAM


E160664E02


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (TSW- - SGND)


    E160698E01
  1. Disconnect the I7 navigation receiver assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I7-12(TSW-) - I7-18(SGND)
    Always
    Below 1 Ω
    I7-12(TSW-) - Body ground
    Always
    10 kΩ or higher

  1. Reconnect the navigation receiver assembly connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER - MICROPHONE AMPLIFIER ASSEMBLY)


    E138082E03
  1. Disconnect the I7 navigation receiver assembly connector.

  1. Disconnect the U7 roof console box assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I7-17 (MACC) - U7-10 (ACC)
    Always
    Below 1 Ω
    I7-19 (MIC+) - U7-9 (MI1+)
    I7-20 (MIC-) - U7-8 (MIC-)
    I7-17 (MACC) - Body ground
    Always
    10 kΩ or higher
    I7-19 (MIC+) - Body ground
    I7-20 (MIC-) - Body ground

  1. Reconnect the navigation receiver assembly connector.

  1. Reconnect the roof console box assembly connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.INSPECT NAVIGATION RECEIVER ASSEMBLY (MACC VOLTAGE)


    E138081E04
  1. Reconnect the I7 navigation receiver assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    I7-17 (MACC) - Body ground
    Ignition switch ACC
    4 to 6 V

  1. Reconnect the navigation receiver assembly connector.



NG
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)
OK


4.REPLACE MICROPHONE AMPLIFIER ASSEMBLY WITH ANOTHER AND CHECK
  1. Replace the telephone microphone assembly with a normal one (Click here).

  1. Check if the same problem occurs again.

    OK:
    Malfunction disappears



NG
REPLACE ROOF CONSOLE BOX ASSEMBLY (Click here)
OK

END (MICROPHONE IS FAULTY)