REAR DIFFERENTIAL CARRIER ASSEMBLY > DISASSEMBLY |
| 1. INSPECT RUNOUT OF REAR DRIVE PINION COMPANION FLANGE SUB-ASSEMBLY |
![]() |
Using a dial indicator, measure the runout of the companion flange vertically and laterally.
| Runout | Specified Condition |
| Vertical runout | 0.1 mm (0.00394 in.) |
| Lateral runout | 0.1 mm (0.00394 in.) |
| 2. REMOVE REAR DIFFERENTIAL SIDE GEAR SHAFT OIL SEAL |
![]() |
Using SST, tap out the 2 differential side gear shaft oil seals.
| 3. REMOVE REAR DRIVE PINION NUT |
![]() |
Using SST and a hammer, unstake the rear drive nut.
![]() |
Using SST to hold the rear drive pinion companion flange sub-assembly.
Using a socket wrench (30mm), remove the rear drive pinion nut.
| 4. REMOVE REAR DRIVE PINION COMPANION FLANGE SUB-ASSEMBLY |
![]() |
Using SST, remove the rear drive pinion companion flange sub-assembly from the rear differential carrier assembly.
| 5. REMOVE REAR DIFFERENTIAL CARRIER OIL SEAL |
![]() |
Using SST, remove the rear differential carrier oil seal.
| 6. REMOVE REAR DIFFERENTIAL DRIVE PINION OIL SLINGER |
![]() |
Remove the rear differential drive pinion oil slinger from the rear differential carrier assembly.
| 7. REMOVE REAR DRIVE PINION FRONT TAPERED ROLLER BEARING |
![]() |
Remove the bearing (inner race) from the differential carrier.
| 8. REMOVE REAR DIFFERENTIAL SIDE BEARING RETAINER |
![]() |
Remove the 12 bolts and 2 straight pin.
Using a plastic-faced hammer, tap out the rear differential side bearing retainer.
| 9. REMOVE REAR DIFFERENTIAL CASE SUB-ASSEMBLY |
![]() |
Remove the differential case from the differential carrier.
| 10. REMOVE DIFFERENTIAL DRIVE PINION |
Remove the differential case from the differential drive pinion.
| 11. REMOVE REAR DIFFERENTIAL BREATHER PLUG OIL DEFLECTOR |
![]() |
Remove the 2 bolts and rear differential breather plug oil deflector.
| 12. REMOVE REAR DIFFERENTIAL CARRIER COVER BREATHER PLUG |
![]() |
Remove the rear differential carrier cover breather plug from the rear differential carrier.
| 13. REMOVE REAR DRIVE PINION REAR TAPERED ROLLER BEARING |
![]() |
Using SST and a press, press out the bearing (inner race).
| 14. REMOVE REAR DRIVE PINION FRONT TAPERED ROLLER BEARING |
![]() |
Using a brass bar and hammer, tap out the bearing (outer race) and washer.
| 15. REMOVE REAR DRIVE PINION REAR TAPERED ROLLER BEARING |
![]() |
Using SST and hammer, tap out the bearing (outer race).
| 16. REMOVE REAR DIFFERENTIAL CASE BEARING |
![]() |
Using SST and a press, press out the bearing (outer race) and plate washer from the bearing retainer.
![]() |
Using SST and a press, press out the outer race and plate washer from the differential carrier.
| 17. REMOVE FRONT DIFFERENTIAL CASE BEARING |
![]() |
Using SST, remove the 2 bearings (inner race).
| 18. REMOVE DIFFERENTIAL RING GEAR |
![]() |
Place matchmarks on the ring gear and differential case.
Remove the 12 bolts.
Using a plastic-faced hammer, tap on the ring gear to separate it from the differential case.