Home › Drivetrain ยท AXLE AND DIFFERENTIAL › STEERING KNUCKLE

STEERING KNUCKLE > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the LH side and RH side.
  2. The procedure listed below is for the LH side.



1. REMOVE FRONT AXLE HUB SUB-ASSEMBLY LH
  1. Remove the front axle hub (Click here).



2. DISCONNECT FRONT SPEED SENSOR LH


    C159315
  1. Remove the clip and bolt.

  1. Disconnect the speed sensor from the steering knuckle.



3. DISCONNECT TIE ROD END SUB-ASSEMBLY LH
  1. Remove the cotter pin and nut.



    C179622E01
  1. Using SST, disconnect the tie rod end LH from the steering knuckle.

    SST
    09610-20012  

    NOTICE:
    1. Do not damage the front disc brake dust cover.
    2. Do not damage the ball joint dust cover.
    3. Do not damage the steering knuckle.



4. DISCONNECT FRONT LOWER BALL JOINT ATTACHMENT LH


C155985
  1. Remove the 2 bolts and disconnect the attachment from the steering knuckle.



5. REMOVE STEERING KNUCKLE LH
  1. Support the front suspension lower arm LH with a jack.

  1. Remove the clip and the nut.



    C155977E01
  1. Using SST, disconnect the upper ball joint from the steering knuckle.

    SST
    09628-62011  

  1. Remove the steering knuckle.



6. REMOVE KNUCKLE GREASE RETAINER CAP LH (for 2WD)


    C159448
  1. Using a screwdriver and hammer, tap out the retainer cap.



7. REMOVE STEERING KNUCKLE OIL SEAL LH (for 4WD)


    C159449
  1. Using a screwdriver and hammer, tap out the oil seal.