Home › Vehicle Interior › HEATING / AIR CONDITIONING › COMPRESSOR (for 3UR-FE, 3UR-FBE)

COMPRESSOR (for 3UR-FE, 3UR-FBE) > REMOVAL

for Preparation Click here



1. DISCHARGE REFRIGERANT FROM REFRIGERATION SYSTEM
  1. Start up the engine.

  1. Switch A/C ON.

  1. Turn the blower switch to ON.

  1. Operate the cooler compressor with an engine speed of approximately 1000 rpm for 5 to 6 minutes to circulate the refrigerant and collect the remaining compressor oil from each component, in the cooler compressor.

  1. Stop the engine.



    I104349E01
  1. Remove the caps from the service valves on the refrigerant line.

  1. Connect the refrigerant recovery unit.

  1. Recover the refrigerant from the air conditioning system using a refrigerant recovery unit.

    NOTICE:
    Use the refrigerant recovery unit in accordance with the manufacturer's instruction manual.



2. REMOVE FAN AND GENERATOR V BELT
  1. Remove the fan and generator V belt (Click here).



3. REMOVE FENDER APRON MUDGUARD SEAL LH


I104333
  1. Remove the 6 clips and seal.



4. DISCONNECT NO. 1 COOLER REFRIGERANT SUCTION HOSE


    I104394
  1. Remove the bolt and disconnect the cooler refrigerant suction hose from the cooler compressor.

  1. Remove the O-ring from the cooler refrigerant suction hose.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.



5. DISCONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE


    I104395
  1. Remove the bolt and disconnect the cooler refrigerant discharge hose from the cooler compressor.

  1. Remove the O-ring from the cooler refrigerant discharge hose.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.



6. REMOVE COOLER COMPRESSOR ASSEMBLY


    I104396
  1. Disconnect the connector.

  1. Remove the 2 bolts and 2 nuts.

  1. Remove the 2 stud bolts and cooler compressor.