GENERATOR > DISASSEMBLY |
| 1. REMOVE GENERATOR PULLEY |
![]() |
| SST 1-A and B | 09820-06010 |
| SST 2 | 09820-06021 |
Clamp the generator housing stay in a vise.
Hold SST 1-A with a torque wrench, and tighten SST 1-B clockwise to the specified torque.
![]() |
Insert SST 2, and attach the pulley nut to SST 2.
![]() |
To loosen the pulley nut, turn SST 1-A in the direction shown in the illustration.
Remove the generator from SST 2.
![]() |
Turn SST 1-B, and remove SST 1-A and B.
Remove the pulley nut and pulley.
| 2. REMOVE GENERATOR REAR END COVER |
![]() |
Place the generator on the pulley.
Remove the 3 nuts and end cover.
![]() |
Remove the terminal insulator.
| 3. REMOVE GENERATOR BRUSH HOLDER ASSEMBLY |
![]() |
Remove the 2 screws and brush holder.
| 4. REMOVE GENERATOR COIL ASSEMBLY |
![]() |
Remove the 4 bolts.
![]() |
Using SST, remove the coil assembly.
Remove the generator washer.
| 5. REMOVE GENERATOR ROTOR ASSEMBLY |