Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING SYSTEM

TIRE PRESSURE WARNING SYSTEM > TERMINALS OF ECU

for Preparation Click here


HINT:
Inspect the connectors from the back side.


CHECK TIRE PRESSURE WARNING ECU

E129452E31

  1. Disconnect the O14 tire pressure warning antenna and receiver connector.

  2. Measure the voltage according to the value(s) in the table below.

    Standard Voltage 
    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    H40-12 (RDA) - H40-9 (GND)
    G - W-B
    Tire pressure warning antenna and receiver signal
    Ignition switch ON
    11 to 14 V

  3. Connect the O14 tire pressure warning antenna and receiver connector.

  4. Measure the voltage and resistance according to the value(s) in the table below.

    Standard 
    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    H40-1 (CLSW) - H40-9 (GND)
    B - W-B
    Tire pressure warning reset switch
    Ignition switch ON
    Tire pressure warning reset switch OFF
    8 to 14 V
    Ignition switch ON
    Tire pressure warning reset switch ON
    Below 1.5 V
    H40-2 (SPD) - H40-9 (GND)
    V - W-B
    Vehicle speed signal
    Vehicle is running
    Pulse generation
    (see waveform 1)
    H40-3 (TC) - H40-9 (GND)
    W - W-B
    TC terminal
    When terminal TC is not connected
    8 to 14 V
    H40-5 (IND) - H40-9 (GND)
    LG - W-B
    Tire pressure warning light output signal
    After ignition switch is turned ON, when tire pressure warning light illuminates for 3 seconds
    2.2 to 4.4 V
    Ignition switch ON
    Tire pressure warning light off
    Below 0.5 V
    H40-6 (RF5V) - H40-9 (GND)
    Y - W-B
    Tire pressure warning antenna and receiver power source
    Ignition switch ON
    11 to 14 V
    H40-7 (IG) - H40-9 (GND)
    Y - W-B
    IG power source
    Ignition switch ON
    11 to 14 V
    H40-9 (GND) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω
    H40-10 (SIL) - H40-9 (GND)
    L - W-B
    Diagnosis tester communication line
    Ignition switch ON, when communication is not performed with a tester
    8 to 14 V
    H40-11 (GND2) - H40-9 (GND)
    P - W-B
    Tire pressure warning antenna and receiver ground
    Always
    Below 1 Ω
    If the result is not as specified, the ECU may have a malfunction.



  5. F047507E05
  6. Using an oscilloscope, check the waveform 1.
    Item
    Content
    Terminal No. (Symbol)
    H40-2 (SPD) - H40-9 (GND)
    Tool Setting
    5 V/DIV., 200 ms/DIV.
    Vehicle Condition
    While driving at approximately 20 km/h (12 mph).