ROOF DRIP SIDE FINISH MOULDING > INSTALLATION |
| 1. INSTALL ROOF DRIP SIDE FINISH MOULDING CLIP |
![]() |
Remove the tape that remains on the moulding surface of the vehicle body, and then clean the surface with a non-residue solvent.
Using an infrared light, heat the clip installation surface on the vehicle body and roof drip side finish moulding.
| Area | Temperature |
| Vehicle Body | 40 to 60°C (104 to 140°F) |
| Roof Drip Side Finish Moulding | 20 to 30°C (68 to 86°F) |
Install new clips in the positions shown in the illustration. Press in the clips by hand.
| Area | Measurement |
| a | 4.7 mm (0.185 in.) |
| b | 5.1 mm (0.201 in.) |
| c | 4.7 mm (0.185 in.) |
| d | 5.0 mm (0.197 in.) |
| 2. INSTALL ROOF DRIP SIDE FINISH MOULDING |
![]() |
Engage the 2 clips and install the roof drip side finish moulding.
Remove the protective tape.