Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › ROOF DRIP SIDE FINISH MOULDING

ROOF DRIP SIDE FINISH MOULDING > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The procedure described below is for the LH side.



1. REMOVE ROOF DRIP SIDE FINISH MOULDING


    B191709E01
  1. Apply protective tape to the roof panel in the area around the roof drip side finish moulding.



    B191710
  1. Disengage the 2 clips and remove the roof drip side finish moulding.

    NOTICE:
    1. Do not remove the clips.
    2. Replace the clips with new clips if damaged.