Home › Audio/Visual/Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM

NAVIGATION SYSTEM > AVC-LAN Circuit

for Preparation Click here


DESCRIPTION

Each unit of the navigation system connected to the AVC-LAN (communication bus) transfers the signal of each switch by communication.
When a short to +B or short to ground occurs in this AVC-LAN, the navigation system will not function normally as the communication is discontinued.

INSPECTION PROCEDURE

1.CHECK NAVIGATION RECEIVER ASSEMBLY


    E145834E12
  1. Disconnect the I20 and I25* navigation receiver assembly connectors.

    HINT:
    *: w/ Rear Seat Entertainment System

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I20-5 (ATX+) - I20-15 (ATX-)
    Always
    60 to 80 Ω
    I25-9 (TXM+) - I25-10 (TXM-)*

    HINT:
    *: w/ Rear Seat Entertainment System

  1. Reconnect the navigation receiver assembly connector.



NG
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)
OK


2.CHECK HARNESS AND CONNECTOR

E138055E05


E145835E05

HINT:
For details of the connectors, refer to "Terminals of ECU" (Click here).

  1. Referring to the AVC-LAN wiring diagram below, check all AVC-LAN circuits.

    1. Disconnect all connectors in all AVC-LAN circuits.

    2. Check for an open or short in all AVC-LAN circuits.

      OK:
      There is no open or short circuit.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)