Home › Drivetrain ยท AB60F AUTOMATIC TRANSMISSION / TRANSAXLE › AIR COOLED OIL COOLER

AIR COOLED OIL COOLER > INSTALLATION

for Preparation Click here



1. INSTALL NO. 1 TRANSMISSION OIL COOLER HOSE


    C179240
  1. Install the 2 No. 1 transmission oil cooler hoses with the 2 clips.



2. INSTALL NO. 2 OIL COOLER TUBE SUB-ASSEMBLY


    C179239
  1. Connect the No. 2 oil cooler tube sub-assembly to the 2 No. 1 transmission oil cooler hoses with the 2 clips.

  1. Install the No. 2 oil cooler tube sub-assembly with the bolt.

    Torque:
    4.9 N*m{ 50 kgf*cm , 43 in.*lbf }



3. INSTALL TRANSMISSION OIL COOLER AIR DUCT


    C179238
  1. Install the No. 1 oil cooler air duct and No. 2 oil cooler air duct with the 4 bolts.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }



4. INSTALL RADIATOR SUPPORT TO FRAME SEAL RH


    C179237
  1. Install the radiator support to frame seal RH with the 2 clips.



5. INSTALL AIR COOLED OIL COOLER ASSEMBLY


    C179236
  1. Install the oil cooler support bracket with the 2 bolts.

    Torque:
    12 N*m{ 122 kgf*cm , 9 ft.*lbf }



    C179235
  1. Temporarily place the oil cooler on the radiator support.

    HINT:
    Securely attach the claw of the oil cooler support bracket into the hole of the radiator support.

  1. Install the air cooled oil cooler assembly with the 3 bolts.

    Torque:
    14 N*m{ 143 kgf*cm , 10 ft.*lbf }



6. INSTALL OIL COOLER TUBE


    C161349
  1. Install the oil cooler tube with the 2 bolts.

    Torque:
    14 N*m{ 143 kgf*cm , 10 ft.*lbf }



7. INSTALL NO. 1 OIL COOLER HOSE


    C161350E01
  1. Install the inlet No. 1 oil cooler hose and outlet No. 1 oil cooler hose with the 4 clips.

    HINT:
    1. Make sure the pinching portion of each clip is facing the direction shown in the illustration.
    2. Make sure the paint portion of each hose is facing outward.

  1. Pass the 2 hoses through the flexible hose clamp and close the clamp.



8. INSTALL NO. 2 OIL COOLER HOSE


    C161351E02
  1. Install the inlet No. 2 oil cooler hose and outlet No. 2 oil cooler hose with the 4 clips.

    HINT:
    Make sure the pinching portion of each clip is facing the direction shown in the illustration.

  1. Install the bolt to fix the water by-pass pipe in place.

    Torque:
    18 N*m{ 184 kgf*cm , 13 ft.*lbf }



9. INSTALL FRONT BUMPER ASSEMBLY
  1. Install the front bumper assembly (Click here).



10. ADJUST AUTOMATIC TRANSMISSION FLUID
  1. Adjust automatic transmission fluid (Click here).



11. INSPECT FOR AUTOMATIC TRANSMISSION FLUID LEAK