Home › Vehicle Exterior › LIGHTING (EXT) › STOP LIGHT SWITCH

STOP LIGHT SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL STOP LIGHT SWITCH ASSEMBLY


F049043E05


  1. Install the stop light switch into the adjuster until it slightly touches the brake pedal.

    NOTICE:
    Do not depress the brake pedal.




      F049044E18
    1. Make a quarter turn clockwise to install the stop light switch.

      NOTICE:
      Do not depress the brake pedal.

      HINT:
      Do not tighten the stop light switch more than the torque specification.

      Torque:
      1.5 N*m{ 15 kgf*cm , 13 in.*lbf }

  1. Check the stop light switch clearance.

    Stop light switch clearance:
    0.5 to 2.6 mm (0.020 to 0.102 in.)

  1. Connect the stop light switch connector to the stop light switch.