Home › Vehicle Interior › LIGHTING (INT) › BACK DOOR COURTESY SWITCH

BACK DOOR COURTESY SWITCH > INSPECTION

for Preparation Click here



1. INSPECT BACK DOOR LOCK ASSEMBLY (w/o Power Back Door)


E161809E01
  1. Check the resistance of the back door courtesy switch.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      3 - 4
      Unlocked
      Below 1 Ω
      3 - 4
      Locked
      10 kΩ or higher

      If the result is not as specified, replace the back door lock.



2. INSPECT BACK DOOR LOCK ASSEMBLY (w/ Power Back Door)


    E161809E01
  1. Check the resistance of the back door courtesy switch.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      3 - 6
      Unlocked
      Below 1 Ω
      3 - 6
      Locked
      10 kΩ or higher

      If the result is not as specified, replace the back door lock.