DTC P0550 Power Steering Pressure Sensor Circuit Malfunction |
DTC P0552 Power Steering Pressure Sensor Circuit Low Input |
DTC P0553 Power Steering Pressure Sensor Circuit High Input |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0550 | Power steering oil pressure sensor voltage less than 0.28 V, or more than 4.9 V for 0.5 seconds while engine running. (1 trip detection logic) |
|
| P0552 | Power steering oil pressure sensor voltage less than 0.28 V for 0.5 seconds while engine running. (1 trip detection logic) |
|
| P0553 | Power steering oil pressure sensor voltage more than 4.9 V for 0.5 seconds while engine running. (1 trip detection logic) |
|

| Related DTCs | P0550: Power steering pressure sensor range check (Chattering) P0552: Power steering pressure sensor range check (Low Resistance) P0553: Power steering pressure sensor range check (High Resistance) |
| Required sensors/components (Main) | Power steering pressure sensor |
| Frequency of operation | Continuous |
| Duration | 0.5 seconds |
| MIL operation | Immediate |
| Sequence of operation | None |
| Monitor runs whenever following DTCs not present | None |
| Time after starter signal ON to OFF | 2 seconds or more |
| Power steering pressure sensor voltage | Less than 0.28 V, or more than 4.9 V |
| Power steering pressure sensor voltage | Less than 0.28 V |
| Power steering pressure sensor voltage | More than 4.9 V |
| 1.CHECK HARNESS AND CONNECTOR (ECM - POWER STEERING OIL PRESSURE SENSOR) |
![]() |
Disconnect the ECM connector.
Disconnect the power steering oil pressure sensor connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D30-2 (PSP) - D56-72 (PSP) | Always | Below 1 Ω |
| D30-1 (VC) - D56-67 (VCV1) | Always | Below 1 Ω |
| D30-3 (E2) - D56-97 (ETHW) | Always | Below 1 Ω |
| D30-2 (PSP) or D56-72 (PSP) - Body ground | Always | 10 kΩ or higher |
| D30-1 (VC) or D56-67 (VCV1) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 2.REPLACE POWER STEERING OIL PRESSURE SWITCH |
Replace the power steering oil pressure sensor (Click here).
| NEXT | |
| 3.CONFIRM WHETHER DTC OUTPUT RECURS |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
| P0550, P0552 and/or P0553 are output | A |
| No DTC is output | B |
|
| ||||
| A | ||
| ||