Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM

POWER STEERING SYSTEM > TERMINALS OF ECU

for Preparation Click here



CHECK POWER STEERING ECU

C179924E01

  1. Measure the voltage and resistance according to the value(s) in the table below.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    H38-2 (GND) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω
    H38-3 (CANL) - H38-2 (GND)
    W - W-B
    CAN communication
    Ignition switch ON
    Pulse generation
    H38-6 (IG1) - H38-2 (GND)
    GR - W-B
    IG power supply
    Ignition switch ON
    11 to 14 V
    H38-8 (CANH) - H38-2 (GND)
    GR - W-B
    CAN communication
    Ignition switch ON
    Pulse generation
    H38-9 (SOF+) - H38-4 (SOF-)
    LG - O
    Power steering solenoid valve signal
    1. Engine idling
    2. Steering wheel turned to right or left
    Pulse generation
    If the result is not as specified, the ECU may have a malfunction.