Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › SIDE AIRBAG SENSOR

SIDE AIRBAG SENSOR > INSTALLATION

for Preparation Click here


CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).

HINT:
The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.



1. INSTALL SIDE AIRBAG SENSOR ASSEMBLY
  1. Confirm that the ignition switch is turned off.

  1. Confirm that the cable is disconnected from the battery negative (-) terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



    B194501E01
  1. Engage the guide and install the airbag sensor with the bolt.

    Torque:
    9.0 N*m{ 92 kgf*cm , 80 in.*lbf }

    NOTICE:
    1. Do not use a side airbag sensor that has been dropped.
    2. Do not subject the side airbag sensor to any impact or force.

  1. Confirm that there is no looseness by shaking the side airbag sensor.

  1. Connect the airbag connector.



2. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY
  1. Connect the connectors.



    B190543
  1. Connect the front door lock remote control cable and the front door inside locking cable.



    B190542
  1. Engage the 10 clips and install the front door trim board sub-assembly.



    B190541
  1. Tighten the 2 screws.

  1. Install the front door armrest cover.



3. INSTALL FRONT ARMREST BASE UPPER PANEL


B190537
  1. Connect the connector.

  1. Engage the 2 clips and 5 claws and install the front armrest base upper panel.



4. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG


    B190540
  1. Engage the 4 claws and install the front door inside handle bezel plug



5. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH


B194240
  1. Engage the 3 clips and install the front door lower frame bracket garnish.



6. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH (for 14 Speakers)


B190538
  1. Connect the connector.

  1. Engage the 3 clips and install the front door lower frame bracket garnish.



7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

CAUTION:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



8. INSPECT SRS WARNING LIGHT
  1. Inspect SRS warning light (Click here).