Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › BRAKE ACTUATOR

BRAKE ACTUATOR > REMOVAL

for Preparation Click here



1. DISCONNECT VSC ACTUATOR CONNECTOR


    C154434
  1. Pull the release bar and disconnect the VSC actuator connector.

    NOTICE:
    Be careful not to allow brake fluid to enter the removed connector.



2. REMOVE BRAKE TUBE


    C154437E02
  1. Use tags or make a note to identify the reconnection locations.



    C155454E04
  1. Using a union nut wrench (10 mm), disconnect the 2 brake tubes from the VSC actuator.



    C155449E06
  1. Using a union nut wrench (10 mm), remove the 2 brake tubes from the brake master cylinder.



3. DISCONNECT BRAKE TUBE


    C155455E04
  1. Using a union nut wrench (10 mm), disconnect the 4 brake tubes from the VSC actuator.

  1. Remove the clamp from the VSC actuator bracket.



4. REMOVE VSC ACTUATOR WITH ACTUATOR BRACKET ASSEMBLY


    C155484
  1. Remove the 3 nuts and VSC actuator with actuator bracket.

    NOTICE:
    Do not damage the brake lines or wire harness.