Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE MASTER CYLINDER

BRAKE MASTER CYLINDER > REMOVAL

for Preparation Click here



1. DRAIN BRAKE FLUID

NOTICE:
Immediately wash off any brake fluid that comes into contact with any painted surfaces.



2. DISCONNECT BRAKE FLUID LEVEL WARNING SWITCH CONNECTOR


C154470
  1. Disconnect the brake fluid level warning switch connector.



3. DISCONNECT FRONT NO. 1 BRAKE TUBE


    C155449E05
  1. Using a union nut wrench, disconnect the brake tube (labeled A) from the brake master cylinder.



4. DISCONNECT REAR NO. 1 BRAKE TUBE
  1. Using a union nut wrench, disconnect the brake tube (labeled B) from the brake master cylinder.



5. REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY

NOTICE:
Remove the brake master cylinder after depressing the brake pedal several times and bleeding the vacuum pressure from inside the brake booster.



    C154471
  1. Remove the 2 nuts and brake master cylinder from the brake booster.

  1. Remove the brake master cylinder seal from the brake master cylinder.