DTC C1793 Height Control Off Switch Circuit |
| DTC Code | Detection Condition | Trouble Area |
| C1793 | Height control mode select switch signal does not change. |
|

| 1.READ VALUE USING TECHSTREAM (MANUAL MODE SWITCH) |
Turn the ignition switch off.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON, and turn the Techstream main switch on.
Enter the following menus: Chassis / Air suspension / Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Manual Mode Switch | Height control mode select switch (Manual)/ ON or OFF | ON: Height control mode select switch ON condition OFF: Height control mode select switch OFF condition | - |
Check that the value displayed on the Techstream changes by pressing the height control mode select switch.
| Result | Proceed to |
| NG | A |
| OK (When troubleshooting according to the Problem Symptoms Table) | B |
| OK (When troubleshooting according to the DTC Chart) | C |
|
| ||||
|
| ||||
| A | |
| 2.INSPECT HEIGHT CONTROL MODE SELECT SWITCH |
Turn the ignition switch off.
![]() |
Remove the height control mode select switch.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 3 (E) - 6 (MSW) | Free | 10 kΩ or higher |
| 3 (E) - 6 (MSW) | Pushed in | Below 1 Ω |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (HEIGHT CONTROL MODE SELECT SWITCH - ECU AND BODY GROUND) |
![]() |
Disconnect the O17 ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| H73-6 (MSW) - O17-24 (TD) | Always | Below 1 Ω |
| H73-3 (E) - Body ground | Always | Below 1 Ω |
| H73-6 (MSW) or O17-24 (TD) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||