DTC C1751 Compressor Relay Coil Malfunction |
| DTC Code | Detection Condition | Trouble Area |
| C1751 | When either of the following is detected:
|
|

| 1.PERFORM ACTIVE TEST USING TECHSTREAM (COMPRESSOR MOTOR RELAY) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON, and turn the Techstream main switch on.
Enter the following menus: Chassis / Air suspension / Active Test.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Compressor Motor Relay | AIR SUS relay | ON or OFF | Operation of solenoid (clicking sound) can be heard |
| Result | Proceed to |
| NG | A |
| OK (When troubleshooting according to the Problem Symptoms Table) | B |
| OK (When troubleshooting according to the DTC Chart) | C |
|
| ||||
|
| ||||
| A | |
| 2.INSPECT SUSPENSION CONTROL RELAY (AIR SUS) |
Turn the ignition switch off.
![]() |
Remove the AIR SUS relay from the engine relay block.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 3 - 5 | When 12 V battery voltage is not applied to terminal 1 and 2 | 10 kΩ or higher |
| When 12 V battery voltage is applied to terminal 1 and 2 | Below 1 Ω |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (SUSPENSION CONTROL RELAY - ECU AND BODY GROUND) |

Disconnect the O16 ECU connector.
Remove the AIR SUS relay from the engine room relay block.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| O16-18 (RC) - Relay block AIR SUS relay terminal 1 | Always | Below 1 Ω |
| O16-18 (RC) or Relay block AIR SUS relay terminal 1 - Body ground | Always | 10 kΩ or higher |
| Relay block AIR SUS relay terminal 2 - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||