Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING ECU

TIRE PRESSURE WARNING ECU > REMOVAL

for Preparation Click here



1. REMOVE FRONT DOOR SCUFF PLATE RH


    B190151
  1. Detach the 9 claws and remove the scuff plate.



2. REMOVE COWL SIDE TRIM BOARD RH


    B190152
  1. Remove the clip.

  1. Disengage the 2 clips and remove the cowl side trim board.



3. REMOVE INSTRUMENT SIDE PANEL RH


    B192338E01
  1. Apply protective tape, as shown in the illustration.

  1. Using a moulding remover, disengage the 3 claws and 3 guides and remove the side panel.



4. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


B192340
  1. Disengage the 4 claws and 2 guides and remove the under cover.



5. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY RH


B192341
  1. Remove the bolt <A> and 3 <D> screws.

  1. Disengage the 4 claws and remove the finish panel.



6. REMOVE TIRE PRESSURE WARNING ECU
  1. Disconnect the tire pressure warning ECU connector.



    C178149
  1. Remove the 2 nuts and the tire pressure warning ECU.