Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › THEFT DETERRENT SYSTEM

THEFT DETERRENT SYSTEM > Engine Hood Courtesy Switch Circuit

for Preparation Click here


DESCRIPTION

The engine hood courtesy switch is installed together with the hood lock. This switch turns off when the engine hood is opened and turns on when the engine hood is closed.

WIRING DIAGRAM


B148196E13


INSPECTION PROCEDURE

1.READ VALUE USING TECHSTREAM
  1. Connect a Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the Techstream main switch on.

  1. Select the item below in the Data List and read the display on the Techstream.

    Main Body 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Hood Courtesy Switch
    Engine hood courtesy switch signal ON/OFF
    ON: Engine hood is OPEN
    OFF: Engine hood is CLOSED
    -

    OK:
    The indicator on the Techstream switches between ON and OFF in accordance with the engine hood courtesy switch status.



NG
Go to step 2
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.INSPECT ENGINE HOOD COURTESY SWITCH


  1. Disconnect the A35 engine hood courtesy switch connector.


    B165961E02

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 2
    LOCK position
    Below 1 Ω
    UNLOCK position
    10 kΩ or higher



NG
REPLACE HOOD LOCK ASSEMBLY (Click here)
OK


3.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - ENGINE HOOD COURTESY SWITCH)


    B160792E02
  1. Disconnect the H4 main body ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H4-16 (HCTY) - A35-1
    Always
    Below 1 Ω
    A35-2 - Body ground
    Always
    Below 1 Ω
    H4-16 (HCTY) or A35-1 - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MAIN BODY ECU