Home › Audio/Visual/Telematics › PARK ASSIST / MONITORING › ULTRASONIC SENSOR (for Rear Side)

ULTRASONIC SENSOR (for Rear Side) > REMOVAL

for Preparation Click here



1. REMOVE REAR QUARTER PANEL MUDGUARD LH


B191653
  1. Remove the 9 screws.

  1. Remove the clip and the rear quarter panel mudguard.



2. REMOVE REAR QUARTER PANEL MUDGUARD RH

HINT:
Use the same procedure as for the LH side.



3. REMOVE REAR BUMPER COVER


B191654E01
  1. Apply protective tape as shown in the illustration.



    B191655
  1. Remove the 8 bolts, 2 screws and 2 clips.



    B195443
  1. Disengage the 2 harness clamps and disconnect the connector.



    B191656
  1. Disengage the 12 claws and remove the rear bumper cover.



4. REMOVE NO. 1 ULTRASONIC SENSOR
  1. Disconnect the sensor connector.



    E146470
  1. While pushing down on the lever with a finger to release the claw, disengage the claw on the other side to remove the ultrasonic sensor.

    HINT:
    The types of the claws on the top and bottom of the sensor are different. Observe the claws carefully before attempting to remove the sensor.



5. REMOVE NO. 1 ULTRASONIC SENSOR RETAINER


    E146469
  1. Disengage the 2 claws and remove the ultrasonic sensor retainer from the rear bumper.



6. REMOVE NO. 2 ULTRASONIC SENSOR
  1. Disconnect the sensor connector.



    E146468
  1. While pushing down on the lever with a finger to release the claw, disengage the claw on the other side to remove the ultrasonic sensor.

    HINT:
    The types of claws on the top and bottom of the sensor are different. Observe the claws carefully before attempting removing the sensor.



7. REMOVE NO. 2 ULTRASONIC SENSOR RETAINER


    E146469
  1. Disengage the 2 claws and remove the ultrasonic sensor retainer from the rear bumper.