Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE PEDAL

BRAKE PEDAL > REMOVAL

for Preparation Click here



1. REMOVE FRONT DOOR SCUFF PLATE LH

HINT:
Use the same procedure for both sides.



2. REMOVE COWL SIDE TRIM BOARD LH

HINT:
Use the same procedure for both sides.



3. REMOVE INSTRUMENT SIDE PANEL LH


    B192331E01
  1. Apply protective tape, as shown in the illustration.

  1. Using a moulding remover, disengage the 3 claws and 4 guides and remove the side panel.



4. REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY


    B192511
  1. Disengage the 3 claws.

  1. Disconnect the hood lock control cable and remove the hood lock control lever sub-assembly.



5. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH


B192333
  1. Remove the 2 <A> bolts.

  1. Disengage the 4 clips and claw.

  1. Disengage the 2 claws and separate the sensor.

  1. Disconnect the connectors and remove the finish panel.



6. REMOVE NO. 1 INSTRUMENT PANEL SAFETY PAD INSERT


B192337
  1. Remove the 4 <A> bolts.

  1. Disengage the 2 claws.

  1. Disconnect the connector and clamp and remove the safety pad insert.



7. REMOVE NO. 1 SIDE DEFROSTER NOZZLE DUCT


    C154523
  1. Remove the bolt and air duct.



8. REMOVE PUSH ROD PIN
  1. Remove the clip and push rod pin from the brake pedal lever.



9. REMOVE STOP LIGHT SWITCH ASSEMBLY
  1. Disconnect the connector.



    E161861
  1. Turn the stop light switch counterclockwise and remove it.



10. REMOVE STOP LIGHT SWITCH MOUNTING ADJUSTER
  1. Remove the stop light switch mounting adjuster.



11. REMOVE BRAKE PEDAL SUPPORT SUB-ASSEMBLY


    C154460E03
  1. Remove the brake pedal return spring.

  1. Remove the bolt from the No. 3 brake pedal bracket.



    C154461
  1. Remove the bolt, nut and No. 3 brake pedal bracket from the brake pedal support.



    C154462
  1. Remove the 4 nuts and brake pedal support.



12. REMOVE BRAKE PEDAL PAD


    C155468
  1. Remove the brake pedal pad.