Home › Vehicle Exterior › WIPER / WASHER › RELAY

RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT HEADLIGHT CLEANER CONTROL RELAY


    E156165E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    6 (PB)- 4 (E)
    When battery voltage is not applied between terminals 3 (IG) and 2 (H)
    10 kΩ or higher
    When battery voltage is applied between terminals 3 (IG) and 2 (H)
    Below 1 Ω (0.8 to 0.9 seconds, then no continuity exists)

    If the result is not as specified, replace the headlight cleaner control relay.