Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENGINE IMMOBILISER SYSTEM

DTC    B2793    Transponder Chip Malfunction

DTC    B2794    Unmatched Encryption Code

DTC    B2795    Unmatched Key Code

for Preparation Click here


DESCRIPTION

  1. B2793 is output when a malfunction is found in the key during key code registration or a key code is not registered normally. Replace the key if the key code registration cannot be performed normally and this DTC is detected.
  2. B2794 is output when a key with an incomplete key code is inserted into the ignition key cylinder.
  3. B2795 is output when a key with a key code that has not been registered in the ECU is inserted into the ignition key cylinder.

DTC Code
DTC Detection Condition
Trouble Area
B2793
When attempting to register an ID code, the registration does not complete normally
Key
B2794
A registered key is inserted into the ignition key cylinder, but key comparison indicates that the security code is incorrect.
B2795
A key with a different ID code (an unregistered key) is inserted into the ignition key cylinder.

INSPECTION PROCEDURE

HINT:
When the transponder key ECU is replaced, reregister the ECU - ECM communication ID .

1.CLEAR DTC
  1. Clear the DTCs (Click here).


NEXT


2.REREGISTER KEY
  1. Reregister the key code with the transponder key ECU .


NEXT


3.CHECK ENGINE START
  1. Check that the engine starts with the key.

    OK:
    Engine starts.



NG
REPLACE KEY
OK

END