ENGINE IMMOBILISER SYSTEM > DATA LIST / ACTIVE TEST |
| READ DATA LIST |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Body Electrical / Immobiliser / Data List.
According to the display on the Techstream, read the "Data List".
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Key SW | Unlock warning switch signal / ON or OFF | ON: Key is in ignition key cylinder OFF: No key is in ignition key cylinder | - |
| IG SW | Ignition switch signal / ON or OFF | ON: Ignition switch ON OFF: Ignition switch ACC or OFF | - |
| Immobiliser | Immobiliser system status / Set or Unset | Set: No key is in ignition key cylinder Unset: Key is in ignition key cylinder | - |
| Permit (Start) | Permit (start) signal / OK or NG | OK: Engine start is permitted NG: Engine start is not permitted | - |
| Response | Transponder chip data / OK or NG | OK: Data OK NG: Data error | - |
| Frame Error | Transponder chip data / OK or NG | OK: Data OK NG: Data error | - |
| Different Serial Number | Transponder chip data / OK or NG | OK: Data OK NG: Data error | - |
| Different Encrypt Code | Transponder chip data / OK or NG | OK: Data OK NG: Data error | - |
| Abnormal Status | Transponder chip data / OK or NG | OK: Data OK NG: Data error | - |
| BCC Malfunction | Transponder chip signal / OK or NG | OK: Correct data sent NG: Incorrect data sent | - |
| Sub Key | Sub-key code signal / Reg or Unreg | Reg: Registered sub-key code is sent Unreg: Unmatched sub-key code is sent | - |
| Master Key | Master key code signal / Reg or Unreg | Reg: Registered master key code is sent Unreg: Unmatched master key code is sent | - |
| Transponder S-code | Number of registered sub-keys / min.: 0, max.: 15 | Number of registered sub-keys | - |
| Transponder M-code | Number of registered master keys / min.: 0, max.: 15 | Number of registered master keys | - |
| Reg Code Space Full | Key registration code memory space full / YES or NO | NO: Possible to register more key codes YES: Cannot register any more key codes | - |
| +B | +B judgment / Normal or Break | Normal: Battery supply is normal Break: Battery supply is malfunctioning | - |
| Antenna Coil Status | Antenna coil condition / Normal or Fail | Normal: Antenna coil is normal Fail: Antenna coil is malfunctioning | - |
| PERFORM ACTIVE TEST |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Body Electrical / Immobiliser / Active Test.
Perform the Active Test according to the display on the Techstream.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Security Indicator | Security indicator light | ON or OFF | - |