Home › Vehicle Exterior › DOOR / HATCH › BACK DOOR SUPPORT

BACK DOOR SUPPORT > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for both the RH and LH sides.
  2. The procedure described below is for the LH side.



1. REMOVE BACK DOOR DAMPER STAY SUB-ASSEMBLY


    B192152E01
  1. Using a screwdriver with its tip wrapped in protective tape, remove the upper side stop ring.



    B192150E01
  1. Using a screwdriver with its tip wrapped in protective tape, remove the lower side stop ring and back door damper stay sub-assembly.



2. REMOVE REAR COMBINATION LIGHT ASSEMBLY
  1. Remove the rear combination light assembly (Click here).



3. REMOVE BACK DOOR SIDE STOPPER


    B195433
  1. Remove the 2 bolts and remove the back door side stopper.



4. REMOVE BACK DOOR STAY COVER


    B195439
  1. Disengage the 3 clips and remove the back door stay cover.



5. REMOVE BACK DOOR STAY LOWER BRACKET


    B195040
  1. Remove the 2 bolts and remove the back door stay lower bracket.



6. REMOVE BACK DOOR STAY UPPER BRACKET


    B192154
  1. Remove the 2 bolts and remove the back door stay upper bracket.