Home › Suspension › FRONT SUSPENSION › FRONT SHOCK ABSORBER

FRONT SHOCK ABSORBER > INSTALLATION

for Preparation Click here



1. TEMPORARILY INSTALL FRONT SHOCK ABSORBER WITH COIL SPRING LH


C155965
  1. Temporarily install the upper side of the shock absorber to the chassis frame with the 4 nuts.



    C155964
  1. Temporarily install the lower side of the shock absorber to the lower suspension arm with the bolt, washer and nut.



2. STABILIZE SUSPENSION
  1. Lower the vehicle.

  1. Press down on the vehicle several times to stabilize the suspension.



3. TIGHTEN FRONT SHOCK ABSORBER WITH COIL SPRING LH


C155964
  1. Tighten the nut.

    Torque:
    195 N*m{ 1988 kgf*cm , 144 ft.*lbf }



    C163294E01
  1. Tighten the 4 upper nuts in diametrically opposite pairs.

    Torque:
    45 N*m{ 459 kgf*cm , 33 ft.*lbf }

  1. Check that the first nut that was tightened is at the torque specification.



4. INSTALL SUSPENSION CONTROL BRACKET (w/ AVS)


C181282
  1. Install the suspension control bracket with the nut.

    Torque:
    15 N*m{ 153 kgf*cm , 11 ft.*lbf }



5. INSTALL ABSORBER CONTROL ACTUATOR (w/ AVS)


C180592
  1. Using a hexagon wrench, install the absorber control actuator with the 2 bolts.

    Torque:
    7.8 N*m{ 80 kgf*cm , 69 in.*lbf }



    C180587
  1. Connect the absorber control actuator connector.



6. INSTALL FRONT WHEEL
  1. for Aluminum Wheel

Torque:
131 N*m{ 1336 kgf*cm , 97 ft.*lbf }

  1. for Steel Wheel

Torque:
209 N*m{ 2131 kgf*cm , 154 ft.*lbf }