Home › Vehicle Interior › DOOR LOCK › WIRELESS DOOR LOCK CONTROL SYSTEM

WIRELESS DOOR LOCK CONTROL SYSTEM > No Answer-Back

for Preparation Click here


DESCRIPTION

In some cases, wireless door lock control functions are normal but the hazard warning lights and/or wireless door lock buzzer answer-back function(s) do not operate. In such cases, the main body ECU's hazard warning lights and wireless door lock buzzer signal outputs may be malfunctioning.

NOTICE:
Troubleshooting should be started after confirming that the customize status of the answer-back function has been switched ON.


WIRING DIAGRAM


B175278E06


INSPECTION PROCEDURE

1.CHECK WIRELESS DOOR LOCK CONTROL FUNCTION
  1. Check the wireless door lock control functions by operating the transmitter switch.
    Result
    Proceed to
    Wireless door lock functions are normal but hazard warning lights answer-back does not occur
    A
    Wireless door lock functions are normal but wireless door lock buzzer answer-back does not occur
    B
    Doors cannot be locked and unlocked with transmitter
    C



B
Go to step 3

C
GO TO PROBLEM SYMPTOMS TABLE (Click here)
A


2.PERFORM ACTIVE TEST USING TECHSTREAM (FLASHER RELAY)
  1. Select the Active Test, use the Techstream to generate a control command, and then check that the hazard warning lights flash.

    Main Body 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Hazard
    Turn Signal Flasher
    ON/OFF
    -

    OK:
    Hazard warning lights are turned ON/OFF.



NG
GO TO LIGHTING SYSTEM (Click here)
OK

REPLACE MAIN BODY ECU 

3.PERFORM ACTIVE TEST USING TECHSTREAM (WIRELESS DOOR LOCK BUZZER)
  1. Select the Active Test, use the Techstream to generate a control command, and then check that the wireless buzzer operates normally.

    Main Body 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Wireless Buzzer
    Wireless Door Lock Buzzer
    ON/OFF
    -

    OK:
    Wireless buzzer turns ON/OFF.



NG
Go to step 4
OK

REPLACE MAIN BODY ECU 

4.CHECK HARNESS AND CONNECTOR (WIRELESS DOOR LOCK BUZZER - MAIN BODY ECU AND BODY GROUND)
E146592E04
  1. Disconnect the A40 wireless door lock buzzer connector.

  1. Disconnect the H1 main body ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A40-1 (B) - H1-7 (BZR)
    Always
    Below 1 Ω
    A40-2 (E) - Body ground
    Always
    A40-1 (B) or H1-7 (BZR) - Body ground
    Always
    10 kΩ or higher

  1. Reconnect the wireless door lock buzzer and main body ECU connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5.REPLACE WIRELESS DOOR LOCK BUZZER
  1. Temporarily replace the wireless door lock buzzer with a new or normally functioning one (Click here).

  1. Check that the buzzer sounds when using the transmitter LOCK and UNLOCK switches.

    NOTICE:
    When battery voltage is directly applied to the buzzer, the buzzer does not sound.

    HINT:
    The buzzer circuit is built into the main body ECU, not into the buzzer itself.



NG
REPLACE MAIN BODY ECU
OK

END (WIRELESS DOOR LOCK BUZZER IS DEFECTIVE)